PPM 300 Shore connection controller

Customisable controller for safe and efficient shore connection handling

PPM 300 (Bus Tie Shaft Generator Shore Connection)
PPM 300 Display Back
PPM 300 Display Top
PPM 300 Display Bottom
PPM 300 Display Side
PPM 300 Rack 4Units Front Codesys
PPM 300 Rack 7Units Front
PPM 300 (Bus Tie Shaft Generator Shore Connection)
PPM 300 Display Back
PPM 300 Display Top
PPM 300 Display Bottom
PPM 300 Display Side
PPM 300 Rack 4Units Front Codesys
PPM 300 Rack 7Units Front

The PPM 300 Shore connection controller controls and protects the system and the shore connection breaker when a shore connection is used. The controller includes pre-programmed sequences for load transfer, blackout close, and breaker open/close, and it supports multiple ship-to-ship supplies.

When a shore connection is in use, it is normally the ship's only power source. However, the controller supports running the gensets in parallel with the shore connection for a limited time.

A DEIF power management system can include as many Shore connection controllers as necessary.

Part of the versatile PPM 300 range

The PPM 300 Shore connection controller is part of the DEIF PPM 300 range of versatile controllers with built-in multi-master power management features. The range offers variants designed for a wide range of marine and offshore applications –from generator control and protection to engineered power management solutions developed for generators, battery energy storage, shore connections, and bus tie breakers. For general information about the PPM 300 range, see the PPM 300 main page.

Highly customisable architecture

All PPM 300 variants can be specified with 4 or 7 I/O module slots. The modules provide voltage and current measurement, I/O, engine control, governor and AVR functions, and communication. Three modules are mandatory, but you can use the remaining 1 or 4 slots to customise the controller by adding modules or leave them empty. In addition, you can add up to 9 expansion racks to a single PPM 300 to get up to 58 free module slots (up to 4 in the base rack and up to 6 in each expansion rack).

Unique ANSI 87G differential protection

With the optional ACM3.2 module, you can add ANSI 87G differential protection for generators. The module measures phase currents on the consumer and neutral sides of a generator in order to detect phase-to-phase faults or phase-to-earth faults in earthed generator systems. With this unique feature, you can design reliable and safe power systems without external differential protection devices.

For a full list of modules, see the Modules tab.

Recommended I/O modules

Slot 1

Slot 2

Slot 3

Slot 4

Slot 5

Slot 6

Slot 7

PSM3.1

ACM3.1

IOM3.1

Blind module

Blind module

Blind module

PCM3.1

The table shows a 7-slot rack, but the controller is also available with a 4-slot rack. Modules PSM3.1, ACM3.1, and PCM3.1 are mandatory. If you add expansion module racks, each expansion rack must contain a PSM3.2 power supply module but does not need to contain other modules.

Other PPM 300 variants

Genset controller

Emergency genset controller

Shaft generator controller

Bus tie breaker controller

Hybrid (battery) controller

Read more

Product videos

Products

Installing the display unit (DU 300)

Introduction to the display unit (DU 300)

Introduction to the PPM 300 controller rack

Protection and Power Management (PPM 300)

Unboxing the display unit (DU 300)

Unboxing the PPM 300

Tutorials

Installing the Multi-line 300 controller rack

Cases

Ferry saves 30 % on fuel consumption